Skip to main content
首页 > 企业资讯 »正文

灯条分板机最多可以切几连片的板

企业资讯 adm1n 2020-10-14 19:52:37 查看评论 加入收藏

简易的灯条分板机是bai一条一条的分,所以du多少片都没都没关系,zhi如果是多组多刀式分板机就dao有限制,因为一次性切割多连片灯条铝基板,这个都是根据的你的板的宽度来决定的。

A simple light bar splitter is a Bai one by one, so it doesn't matter how many pieces of Du. If it is a multi group multi knife type plate splitter, there is a limit on Dao, because cutting multiple pieces of light strip aluminum substrate at one time is determined by the width of your plate.

市面上常见的灯条分板机多为三刀式灯条分板机,机器采用独特的切割方法,电路板切割由六片刀片完成,上下两片为一组,构成一个切割单元。分别是A、B、C、三组。整个切割过程分为三个阶段,A组刀片先切割电路板40%,接着B组刀片再次从A刀片切过的槽中碾过,再次完成40% 的切割量,最后由C组刀片切割最后的20% 并修光,由于每次的切割量很小,因此切割过程中产生的应力较传统的一次切断方式减少了80% 以上。分割好的电路板边缘平整光滑、板面非常平整、不扭不翘。是目前市面上唯一的能保证切割后铝基板不变形的机器。

The common light strip dividing machine on the market is mostly three knife type light strip dividing machine. The machine adopts a unique cutting method. The circuit board cutting is completed by six blades, and the upper and lower two pieces form a group, forming a cutting unit. They were group A, group B, group C and group C. The whole cutting process is divided into three stages. Group a blades first cut 40% of the circuit board, then group B blades again roll through the slots cut by blade a, finish 40% of the cutting volume again, and finally cut the last 20% and polish by group C blades. Because the cutting amount is very small each time, the stress generated in the cutting process is reduced by more than 80% compared with the traditional one-time cutting method. The edge of the divided circuit board is flat and smooth, and the board surface is very flat without twisting and warping. It is the only machine on the market to ensure that the aluminum substrate is not deformed after cutting.

宇顺力三刀式灯条分板机,切板不变形,无毛刺,。

技术参数:

电源:单相AC230/110V 50-60HZ,40W

最大分板长度:无限制

分板速度:80,120,200,400mm/s

分板厚度:0.2-5.0mm

机器尺寸:L380*W325*H333mm

包装尺寸:L390*W340*H340mm,

净重:33Kg

包装重量:43KG

刀具材质:SKD61进口高速钢


旺奕纸箱

留言与评论(共有 0 条评论)
   
验证码:
微信